805
Users Manual
16
Audio
The Meter has an audio connector for headphones.
Headphones are useful for detection of unusual machine
sounds.
To listen to a machine:
1. Open the connector cap of the Meter and connect
the audio connector.
2. Put on the headphones.
3. Push and continue to hold .
4. Push the sensor tip onto the test surface.
As you continue to hold and Meter position
with a consistent force, the audio channel is
active. The Meter also takes a measurement at
this time.
Figure 4 shows how to make the audio connection to the
Meter.
gqi04.eps
Figure 4. Audio Connection
To Next Page
Loading...
