805
Users Manual
4
Accuracy (typical)
-20 °C to 120 °C
(-4 °F to 248 °F) .......................... ±2 °C (4 °F)
120 °C to 160 °C
(248 °F to 320 °F) ....................... ±3 °C (6 °F)
160 °C to 200 °C
(320 °F to 392 °F) ....................... ±4 °C (7 °F)
Note
The specified accuracy is applicable only when the Meter is in
thermal equilibrium with its environment. Accuracy is not
specified when the target temperature is more than 20
°
C
(36
°
F) below the temperature of the Meter.
Focal length ........................................ Fixed, at ~3.8 cm (1.5 in)
External Sensor
Frequency Range ............................... 10 Hz to 1,000 Hz
Bias Voltage (to supply power) ........... 20 V DC to 22 V DC
Bias Current (to supply power) ........... 5 mA
Note
Fluke supports, but does not provide, external sensors.
Vibration Meter
Low Frequency Range
(overall measurement) ........................ 10 Hz to 1,000 Hz
High Frequency Range
(CF+ measurement)............................ 4,000 Hz to 20,000 Hz
Vibration Limit .................................... 50 g peak (100 g peak-peak)
Battery Type ....................................... AA (2) 1.5 V lithium
recommended type: Energizer L91
Ultimate Lithium
Battery Life .......................................... 250 measurements
A/D Converter ..................................... 16-bit
Sampling Rate
Low Frequency ........................... 20,000 Hz
High Frequency ........................... 80,000 Hz
Signal to Noise Ratio .......................... 80 dB
Real Time Clock Backup ..................... Coin Battery
Size (L x W x H) .................................. 24.1 cm x 7.1 cm x 5.8 cm
(9.5 in x 2.8 in x 2.3 in)
Weight ................................................. 0.40 kg (0.89 lb)
Connectors .......................................... USB Mini-B 7-pin, Stereo Audio
Output Jack (3.5 mm Audio Plug),
External Sensor Jack (SMB
connector)
Firmware
External Interfaces .............................. USB 2.0 (full speed)
communication
Data Capacity ..................................... Database on internal flash memory
Upgrade .............................................. through USB
Memory ............................................... Up to 3,500 measurements
Environmental
Operating Temperature ....................... -20 °C to 50 °C (-4 °F to 122 °F)
Storage Temperature .......................... -30 °C to 80 °C (-22 °F to 176 °F)
Operating Humidity ............................. 10 % to 95 % RH (non-condensing)
Operating/Storage Altitude .................. Sea Level to 3,048 meters
(10,000 feet)
IP Rating ............................................. IP54
Vibration Limit ..................................... 500 g peak
Drop Test ............................................ 1 meter
Radiated Emission
Electrostatic Discharge: Burst ............. Standard EN 61000-4-2
To Next Page
Loading...
