Fluke 8505A - Page 52

LINE FEED
Suppress Line Feed Character
COMMAND
CHARACTERS
This character suppresses the LF character normally
sent at the end of a response line.
Transmit Line Feed
Character
This character disables the
"J"
character; the "LF”
character will be sent.
Suppress Output of Readings
^
ln the 8500A, use of J1 will suppress all output from the
DMM. In the 8502A, use of J1 will suppress output with
the
following exceptions: Service Request (SRQ),
status,
recalled
values.
While in the J1 mode, use
of
the
recall command
"G
?"
will retrieve a reading.
Use
of
"J"
or "JO" will exit the
"J1"
mode.
CALIBRATION CONSTANT
When the Calibration Memory (Option -04) module is installed, the "M" character will
inhibit
the adjustment of
readings
by the Calibration Memory
correction factor. A slight increase in
the speed
of readings will
result.
r
\
M
Inhibit
Calibration
Memory
Factors
This
set
of
command characters is available
for
the 8502A
with the Isolator Option -08A.
Activate
Externa! Triggering Mode,
interrupt
when
Ready
Deactivate External
Triggering Mode
Activate External Triggering
Mode, Transmit
when
Ready
This character
enables the External Triggering
mode.
Any external TTL trigger then initiates
a
reading and
interrupts when ready (SRQ).
The
Q1 character also enables External Triggering
mode.
Any external TTL trigger initiates and transmits
a reading.
NOTE
The
"?"
and
characters remain
operative during External Triggering.