Need help?Do you have a question about the Fluke 8845A and is the answer not in the manual?
General| Frequency Range | 3 Hz to 300 kHz |
|---|---|
| DC Voltage Range | 100 mV to 1000 V |
| AC Voltage Range | 100 mV to 750 V |
| DC Current Range | 100 μA to 10 A |
| Resistance Range | 100 Ω to 100 MΩ |
| Resistance Accuracy | 0.01 % |
| Display | 5.5 digit |
| Connectivity | RS-232 |
| AC Current Range | 100 μA to 10 A |
| Frequency Accuracy | 0.01 % |
| Dimensions | 88 mm |
| AC Voltage Accuracy | ±(0.06% + 0.03%) |
| Power Supply | 100 V to 240 V AC, 47 Hz to 63 Hz |
Details configuration for IEEE-488, RS-232, and Ethernet ports for remote control.
Explains how to switch between SCPI, Fluke 45, and Fluke 8842A command languages.
Covers meter input processing, output handling, and measurement triggering mechanisms.
Details status registers, service requests, error handling, and calibration commands.
Covers MEASure, CONFigure, SENSe, and Triggering commands for setting up measurements.
Details SCPI commands for performing math operations, limits, and statistics.
Covers system-related commands, RS-232/Ethernet interface commands, and emulation mode selection.
Details Fluke 45 commands, compatibility, limitations, ranges, and rates.
Covers 8842A commands, syntax, emulation limitations, and operational differences.
Lists and describes various execution, configuration, and calibration error codes.
Details differences and incompatibilities for Fluke 45 and 8842A emulation modes.
Provides information on network communication, IP addressing, and setup.
To Next Page
