Need help?Do you have a question about the Fluke 88 V and is the answer not in the manual?
General| Brand | Fluke |
|---|---|
| Model | 88 V |
| Category | Multimeter |
| Language | English |
Provides contact information for Fluke customer support and service.
Outlines hazards and precautions for using the meter safely.
Describes the function of each input terminal on the multimeter.
Details the functions associated with each position of the rotary switch.
Explains the function of each pushbutton on the multimeter.
Describes the various indicators and symbols shown on the multimeter's display.
Lists and explains various messages displayed by the meter during operation.
Explains how to activate special functions by holding buttons during power-up.
Describes the meter's automatic power-off feature and how to disable it.
Details the warning system for incorrect lead placement.
Instructions for measuring AC and DC voltages with the multimeter.
Guide for measuring temperature using the multimeter and a thermocouple.
How to perform continuity tests using the meter's audible beeper function.
Procedures for measuring electrical resistance with the multimeter.
Explains how to use the meter's conductance function for high resistance measurements.
Steps for measuring capacitance values using the multimeter.
How to test diodes and semiconductor junctions using the meter.
Detailed steps for safely measuring DC and AC current with the multimeter.
Guide on how to measure frequency of voltage or current signals.
Instructions for measuring the duty cycle (on/off time) of signals.
How to determine the time duration of high/low signal pulses.
How to activate and use the bar graph zoom feature via power-up.
Explains the benefits and applications of the bar graph's zoom mode.
Explains how to use the high-resolution display mode for increased accuracy.
How to record minimum, maximum, and average readings over time.
How to enable a smoothing feature for steadier readings.
How to use AutoHOLD to capture and display stable readings.
Introduces typical automotive testing scenarios using the meter.
Guide for measuring engine revolutions per minute (RPM) using the meter.
How to test MAP/BP sensors using the frequency measurement function.
Steps to measure the internal resistance of ignition coils.
How to measure the pulse width of port fuel injector signals.
Procedure to test alternator ripple voltage to check diode health.
How to measure voltage output from a typical oxygen sensor.
Method for measuring voltage drop in the starter circuit.
How to test the voltage output of a throttle position sensor.
How to test the resistance of a throttle position sensor.
Procedure to find a circuit causing excessive current drain in a vehicle.
How to measure battery system voltage.
How to test the continuity of a switch using the multimeter.
Basic cleaning and care instructions for the multimeter.
Procedures for testing the fuses within the multimeter.
Step-by-step guide for replacing the multimeter's battery.
Instructions for examining and replacing the multimeter's fuses.
Lists general technical specifications and operating conditions for the meter.
Provides in-depth technical details and accuracy specifications for various functions.
To Next Page
