4
SURFACE SPEED AND LENGTH
Surface speed and length can be measured using the mechanical adapter and
contact wheel.
Range
0.1 m 6 ”
m/min 0.10 to 1999 0.10 to 1524
ft/min 0.40 to 6550 0.40 to 5000
in/min 4.0 to 78700 4.00 to 60000
m/sec 0.10 to 33.30 0.10 to 25.40
ft/sec 0.10 to 109 0.10 to 83.33
m 0 to 99999
ft 0 to 99999
in 0 to 99999
CONTACT WHEEL USE
Insert mechanical adapter into the top of the Tachometer. See Figure 1.1.
Select either the 0.1 m or 6 inch contact wheel to use.2.
Set the Tachometer to 0.1 or 6 inch setting for the contact wheel in use.3.
Use 4. F to select units of measure.
Contact wheel to surface to measure and press 5.
Oto take measurements.
When the Tachometer is triggered, the trigger symbol flashes and the 6.
measurement is displayed.
MAX, MIN AND AV READINGS
Press Mto enable MAX, MIN and AV readings stored in memory. Each time
a new measurement is taken, the maximum, minimum, average and last
value are stored. The last value is shown under MEM. The units of measure
for the stored readings will also be displayed. Press
O to exit the memory
display mode.
To Next Page
Loading...
