5100B
CBANGE: MP27;HANDLE, F?ONT PANEL14231781895361423178;2
TO:
MP27
IHANDLE* FRONT PANEt1495~903'189536~4959G3i2~~
On page 5-5:
CHANGE: MP16 (4)
TO: MP16 (2)
ADD:
“MP43
(2)” to the Front Corner
Decal.
CHANQE #13 - 13337
Rev.- L, Al 1 Ranging PCB Assy. (5100A-4040T)
On page
5-68:
CHAHGE: CR1 I DIODE, SI, AI-SPEED
SWITCHXNG120332~3l079lOllN4448127~6
TO:
CR1 IDIODE, SI, RECTIFXNR~3687381~7910~~1N4001 12
CEANGE: CR21DIODES SI, HI-SPEED SWITCHING1,20,33,23; 07910l,l,N4448iRSF
TO: CR2 IDIODE, Sf, RE~CTIFIER~368738t079lO~~~N4OOl~REF
For CR5, change the TOT PTY,
FROt4,~REP, TO: 24 'and add "6" to
the REC QTE column.
CHANGE 614 - 13372
Rev.-
D, Al5 Digital-to-Analog Converter PCB ,Assy
On rmae 5-81:
.' ,( 51 ObA-4060T)
CHBNGE: CR5
TO:
CR5
CBAHGE: CR7
TO:
CR7
on page 8-29
Change the v
ERRATA t2
DIODE, FET, CURRENT tlMITER1334,714
DIODE, FET, CURRENT LIMITER 1429373
~07910lTC~R5315~2t1
+8,9536 1429373 I2 I1
DIODE, FET,
CURRENT L~NITEAl334714107910lTCR5315lRNF
DIODE, FET,
CURRENT LIMITER 1,4,2~9373 I89,536,1 429373: REP
alue of CR5 and CRT, FROM: 5.2,'TO: 3.
On page
5-72:
ADD: W41WIRE, RELAY RETAINING
(NOT
SHOWN)~~3764591~~7~342l20C249l2
On page 5-89:
ADD:
W~~WIRE, RELAY RETAINING (NOT SROwN)l376459177342i2OC249l2
On page 5-96:
Change the value of R113, FROM: 21.5, TO: 191.
On page 5-97:
Change the value of 8162, PROM: 21.5, TO: 191.
On page 5-99:
ADD: wl IWIRE, RELAY RETAINING (NOT SHOWN) 137645917734212OC24912
8/80
To Next Page
Loading...
