Manual Supplement BT520 Users
4 3/15
View Test Readings on the Screen
This is a typical display of battery test in Meter mode.
This is a typical display of battery test in Sequence mode:
Battery number: Indicates the number of the battery that has been tested.
Progress bar: The progress bar is generated according to the total number of batteries in the profile.
Each cell corresponds to one battery. An empty cell indicates the corresponding battery is not tested
yet. A full cell indicates the corresponding battery has been tested and the readings have been
saved. A cross mark in a full cell indicates that the threshold function is enabled.
Cursors: Use and to move the cursors. The number of the currently tested battery changes
accordingly. When the cursors are positioned on a full cell, the corresponding reading of that battery
will be shown under the progress bar.
Average readings: After two or more sets of test readings are saved, the Product shows the
average readings, including average resistance and average voltage.
Tip: If the test readings of a battery are significantly different from the average readings, it could
indicate the battery health has been compromised.
Measure Strap resistance in sequence mode
A strap string is created right behind battery string automatically in the same profile. The strap
number equals to battery number. Push the Strap softkey to switch to strap string test. The display
shows to indicate strap string. Push Battery softkey to switch back to battery string test.
To Next Page
Loading...
