Need help?Do you have a question about the Fluke CableIQ CIQ-100 and is the answer not in the manual?
Essential safety warnings for operating the tester, covering potential hazards.
Diagram and instructions for connecting to a data link via a patch panel.
Diagram and instructions for connecting to cabling in a bus topology.
Diagram and instructions for connecting to cabling in a star topology.
Tests for opens and shorts on modular jacks or coaxial connectors.
Checks cable pairs for crosstalk and impedance faults on twisted pair cabling.
General| Model | CIQ-100 |
|---|---|
| Wiremap | Yes |
| Length Measurement | Yes |
| Distance to Fault | Yes |
| Voltage Protection | Yes |
| Display Type | LCD |
| TDR | Yes |
| Storage Temperature | -20 °C to 60 °C |
| Cable Types Supported | Category 5e, Category 6, Category 6A |
| Testing Capability | Wiremap, length |
| Supported Standards | ISO/IEC 11801 |
| Battery Type | AA Alkaline |
| Battery Life | 20 hours of typical use |
| Operating Temperature | 0°C to 50°C |
| Dimensions | 17.8 cm x 8.9 cm x 4.5 cm |
| Weight | 0.55 kg |
To Next Page
