Need help?Do you have a question about the Fluke CertiFiber and is the answer not in the manual?
General| Type | Optical Loss Test Set |
|---|---|
| Wavelengths | 850 nm, 1300 nm, 1310 nm, 1550 nm |
| Fiber Types | Multimode |
| Measurement Accuracy | ±0.2 dB |
| Connector Types | LC, SC, ST |
| Display | Color LCD |
| Model | CertiFiber Pro |
Details the function of each button on the CertiFiber unit for operation and navigation.
Details the function of each button on the CertiFiber unit for operation and navigation.
Step-by-step guide for performing an Autotest on a fiber link using the CertiFiber.
How to select and configure Autotest standards for fiber link certification.
Guide on how to customize Autotest settings and create new custom Autotests.
Instructions on how to transfer test results to a PC using Scanlink Tools software.
Explains the process of establishing a reference value for accurate loss measurements.
How to set the reference value specifically for loopback testing scenarios.
Describes the automated cable testing process that checks results against standards.
How to view the results of an Autotest, including pass/fail indications and measurements for each fiber.
How to run an Autotest for a single cable using a loopback configuration.
How to use the Power Meter function to measure optical power loss at 850nm and 1300nm.
To Next Page
