Fluke i400s Calibration Information

®
PN 2414327 February 2005
© 2005 Fluke Corporation. All rights reserved. Printed in U.S.A.
1
i400s
AC Current Clamp
Calibration Information
Introduction
XWWarning
To avoid electric shock or injury, do not perform the performance tests or
calibration procedures unless you are qualified to do so.
The information provided in this manual is for the use of qualified personnel
only.
The i400s Calibration Information provides the information necessary to verify the performance and
adjust the calibration of the Fluke i400s AC Current Clamp, hereafter known as the Current Clamp.
The following information is included in this document:
• Safety Information and Electrical Symbols
• Specifications
• Maintenance
• Performance Tests
• Calibration Adjustment
• User-Replaceable Parts
• Warranty Statement
See the i400s Instruction Sheet for complete operating instructions.
w ww . . co m
information@itm.com1.800.561.8187

Fluke i400s Specifications

General

Category	AC current clamp
Output	1 mV/A
Frequency Range	50 Hz to 400 Hz
Safety Rating	CAT IV 600 V
Connector	Banana plugs
Current Range	0 to 400 A AC