Fluke iSee TC01A - Cleaning the Lens

2
TC01A
Users Guide
Cleaning the Lens
Always keep the lens clean. A clean lens is important to good pictures and accurate measurements. To
clean the lens:
1. Lightly blow o󰀨 loose particles with canned air or a small squeeze bellows.
2. Gently brush o󰀨 any remaining particles with a soft camel hair brush or a soft lens tissue.
3. Clean remaining dirt using a cotton swab or soft lens tissue dampened in distilled water. Do not scratch
the surface.
4. For ngerprints or other grease, apply Ethanol or denatured alcohol to the lens. Wipe gently with a soft,
clean cloth until you see colors on the surface, then allow to air dry.
5. If silicones (used in hand creams) get on the window, gently wipe the surface with Hexane. Allow to air dry.
Specications
General Specications
Connector Type-C
Operating Temperature 0 °C to +40 °C (32 °F to 104 °F )
Storage Temperature -30 °C to +60 °C (-22 °F to 140 °F)
Operating Humidity 10% to 90% RH
,
Non condensing
Power Consumption 350 mW (Typical)
Ingress Protection (IP) Rating IEC 60529: IP54 (with type-C connector covered)
Operating Altitude 2000 m
Storage Altitude 12000 m
Size (L x W x H) 60 x 33.5 x 11.2 mm
Weight 22 g
Electromagnetic Compatibility (EMC)
International
IEC 61326-1: Portable Electromagnetic Environment
CISPR 11: Group 1, Class A
Group 1: Equipment has intentionally generated and/or uses conductively-coupled radio frequency energy
that is necessary for the internal function of the equipment itself.
Class A: Equipment is suitable for use in all establishments other than domestic and those directly
connected to a lowvoltage power supply network that supplies buildings used for domestic purposes.
There may be potential diculties in ensuring electromagnetic compatibility in other environments due to
conducted and radiated disturbances.
Caution: This equipment is not intended for use in residential environments and may not provide adequate
protection to radio reception in such environments.
Korea (KCC) Class A equipment (Industrial Broadcast & Communications Equipment)
Class A: Equipment meets requirements for industrial electromagnetic wave equipment and the seller or
user should take notice of it. This equipment is intended for use in business environments and not to be
used in homes.
USA (FCC)
47 CFR 15 subpart B. This product is considered an exempt device per
clause 15.103.