Familair with the Power Supply 4 - 9
4.4.2 Settin
e
Do not connect any load. The +V and +S terminals must be interconnected as well
as the -V and -S terminals.
1) Set the volta
e of the selected output channel to 5V by pressin
:
The display shows:
2) Enter the output volta
Check that the display reads approximately 5V. Also check that the CV
annunciator is on, indicatin
that the selected output channel is in the
Constant Volta
e trip level to 7V by pressin
:
The display shows:
4) Enter the overvolta
e of the selected output channel to 8V by pressin
:
The display shows:
6) Enter the output volta
, and
check that the display reads:
7) Set the output volta
e to 6V and reset the overvolta
:
Check that the display reads approximately 6V.
V 5
n 5VSET V
OVP 7
n VSET V7O
ENTER
V 8
n VSET
8 V
nEOVER GVOLTA
V 6 ENTER RESET
To Next Page
Loading...