Fluke ProcessMeter 789 Safety Information Guide

Safety Specifications
Battery Type: 1.5 V, 0-15 mA, AA, Alkaline
Temperature:
Operating temperature: -20 °C to 55 °C
Storage temperature: -40 °C to 60 °C
Altitude: Operating altitude: 2000 meters maximum
Frequency Overload Protection: 10
6
V Hz max
Symbols
Symbol Description

Risk of Danger. Important information. See Manual.

Conforms to European Union directives

Conforms to relevant North American Safety
Standards

Battery

Hazardous voltage

Conforms to relevant Australian EMC requirements

Fuse
CAT III
Measurement Category III is applicable to test and
measuring circuits connected to the distribution part
of the building’s low-voltage MAINS installation.
CAT IV
Measurement Category IV is applicable to test and
measuring circuits connected at the source of the
building’s low-voltage MAINS installation.

Double Insulation

Alternating current

Direct current

To 610101
2nd Edition
Meets Underwriters’ Laboratories safety
requirements

Earth ground

Inspected and licensed by TÜV Product
Services

This product complies with the WEEE Directive
(2002/96/EC) marking requirements. The affixed
label indicates that you must not discard this
electrical/electronic product in domestic household
waste. Product Category: With reference to the
equipment types in the WEEE Directive Annex I, this
product is classed as category 9 "Monitoring and
Control Instrumentation" product. Do not dispose of
this product as unsorted municipal waste. Go to
Fluke’s website for recycling information.

Fluke ProcessMeter 789 Specifications

General

Diode test	Yes
Frequency range	0 - 19.999 kHz
AC current range	0 - 1 A
AC voltage range	0 - 1000 V
Resistance range	0 - 40000000 Ω
Resolution (AC voltage)	0.1 mV
Dimensions (WxDxH)	100 x 203 x 50 mm

Weight and Dimensions

Weight	610 g