EasyManuals Logo

Fluval FX5 User Manual

Fluval FX5
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
EN-6
2. Place the two rim connectors over the back top edge of the aquarium. Place one just above
the spot where you want to place the intake tube; place the other just over the spot where
you want to position the output nozzle. Be sure that the long end of the bracket is on the
inside of the aquarium.
The rubber rings on the connectors are designed to help them adhere to tank glass better.
If the aquarium walls are thinner than 5/8” (1.58 cm) replace the rubber ring with the four
smaller suction cups provided.
Important: Be sure to position the intake tube away from any air source—an air stone, an
aeration device, protein skimmer or the output valve. Air entering the intake strainer will
diminish filter efficiency.
INSTALLATION AND USE
Note: A dropped ledge rim requires purchase
of an extra rim connector. (See “Replace-
ment Parts” for ordering information.)
Alternate Configurations

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluval FX5 and is the answer not in the manual?

Fluval FX5 Specifications

General IconGeneral
Filter TypeCanister
Media Baskets3
Flow Rate925 gallons per hour
Aquarium CapacityUp to 400 gallons
Pump Output925 GPH (3500 L/H)
Wattage48 watts
Voltage120 V / 60 Hz
Hose Diameter1 inch

Related product manuals