4. Assemble the helm tubes in the rudder boxes, do not forget the helm tube bearings (open
rings). Allow helm tubes to exceed 5 mm to the rear.
5. Insert crossbar.
6. Raise the rear of the boat so that you can low down the rudders of about 80 centimeters.
Measure the distance between the two leading edges of the rudders on same height, do the
same for the trailing edges. Compare these two measures and adjust them using the screw
adjuster on the crossbar in order to have the same value.
3.2. Stick
Screw the stick to crossbar.
To Next Page
Loading...