10.3. Gennaker
1. Set the jib furler in accordance with the accompanying leaflet
2. Attach the furler to the gennaker tack webbing side opening to the rear.
3. Attach the furler disc at the end of the pole, attach the gennaker head to the SP1305 halyard
using the corresponding shackle (Big box/mast/ropes).
4. Pass the furler rope through the disc.
5. Attach to the gennaker sheet point the gennaker sheet strop, pass the gennaker sheet as per
the picture.
6. Attach the gennaker rope to the elastic band T1116.
To Next Page
Loading...