FlyInside Bell 47G-2A1 - Flight Controls Setup; Essential Control Bindings

3. Flight Controls Setup
The FlyInside Bell 47G should work with your standard Microsoft Flight
Simulator control bindings. At a minimum you’ll need the following
controls
1. Bind the joystick axis you’d like to use for cyclic roll (left/right)
control to the MSFS “Ailerons Axis”
2. Bind your cyclic pitch (fore/aft) control to the MSFS “Elevator Axis”
3. Bind your pedals or yaw control to the MSFS “Rudder Axis”
4. Bind your collective control (or throttle paddle) to the MSFS
“Throttle Axis”