EasyManuals Logo

Flymo EasiLife User Manual

Flymo EasiLife
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
CAUTION: Cutting the grass too low
right after installation can damage the wire
insulation. Damage to the insulation may
not cause disruptions until several weeks or
months later.
1. Put the boundary wire and the guide wire on the
ground.
2. Put the stakes at a maximum of 100 cm / 40 in.
distance from each other.
3. Attach the stakes to the ground with a hammer or a
plastic mallet.
Note: The wire is overgrown with grass and not visible
after a few weeks.
3.7 To bury the boundary wire or the
guide wire
Cut a groove in the ground with an edge cutter or a
straight shovel.
Put the boundary wire or the guide wire 1-20 cm /
0.4-8 in. into the ground.
3.8 To extend the boundary wire or the
guide wire
Note: Extend the boundary wire or the guide wire if it
is too short for the work area. Use original spare parts,
for example couplers.
1. Disconnect the charging station from the power
outlet.
2. Cut the boundary wire or the guide wire with a pair
of wire cutters where it is necessary to install the
extension.
3. Add wire where it is necessary to install the
extension.
4. Put the boundary wire or the guide wire into
position.
5. Put the wire ends into a coupler.
Note:
Make sure that you can see the ends of
the boundary wire or the guide wire through the
transparent area of the coupler.
6. Push down the cover on the coupler with
adjustable pliers to attach the wires in the coupler.
7. Put the boundary wire or the guide wire into
position with stakes.
8. Connect the charging station to the power outlet.
3.9 After the installation of the product
3.9.1 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
Indicator lamp in the charging station on page 40
and
To install the charging station on page 18
.
3.9.2 To do the basic settings
Before the product starts to operate for the first time, you
must do the basic settings.
1. Put the product in the charging station.
2. Push the ON/OFF button for 3 seconds.
Note:
If the battery is very low, the product must
charge before you can set the product to ON.
3. Push the arrow buttons and the OK button. Select
language, country, date, time, starting point and
set a PIN code.
Note:
It is not possible to use 0000 as PIN code.
20 - Installation 1392 - 007 -

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Flymo EasiLife and is the answer not in the manual?

Flymo EasiLife Specifications

General IconGeneral
TypeRobotic Lawn Mower
Cutting Width16 cm
Cutting Height20-50 mm
Typical Mowing Time on One Charge65 min
Battery TypeLithium-Ion
Battery Voltage18 V
Pin CodeYes
Lift SensorYes
Tilt SensorYes
Battery Capacity2.1 Ah
Typical Charging Time60 minutes
Sound Level Guaranteed (LWA)58 dB

Related product manuals