Flyzone B-25 mitchell - Control Surface and Motor Setup; Centering Control Surfaces; Reversing Control Throws; Arming the Motors

Press and hold one of the corresponding
control surface trim buttons and cycle the
power off and then on to reverse any control
surface direction. Hear a «Beep Beep Beep» sound.
9
If you ever need to reverse
the control throws, follow
this simple procedure.
CAUTION: Unplug the battery
in the model before attempting
to reverse the control throws.
Before ight, center elevator control
surface with elevator trim adjustment.
Before ight, center rudder control
surface with rudder trim adjustment.
Before ight, center aileron control
surface with aileron trim adjustment.
CENTER THE CONTROL SURFACES
REVERSE THE CONTROL THROWS
Keep hands and onlookers clear of propeller during arming and operation.
Switch on the transmitter and
position the throttle control stick
in the low or minimum position.
Plug the battery into plane.
Return the throttle control stick to
the minimum position. Hear
«Beep Beep» sound. The motors are
now armed and the propellers will
operate if the throttle stick is raised.
Raise the throttle control stick
to the maximum or high position.
Hear a «Beep» sound.
ARM THE MOTORS