After you have setup all settings by clicking „Save Settings“ the tunnel shall be establis-
By clicking the „Back“ button you will get a list of tunnels.
Here you have the possibility to activate the tunnel. Also can be displayed status informati-
ons and a „restart“ can be released. To edit the tunnel click on the tunnel name.
General settings are made here.
In case it is used as DNS server, the
directly over the host name. The domain name can be added to the host name.
The password for the web interface can also be changed. Standard is an empty pass-
word. Please keep in mind that HTTP transmits passwords uncoded (also at the login). In
case you are in an insecure network, use HTTPS.
generates its own HTTPS certificate with
corresponding key. But you can also deposit an own certificate. This certificate can for
example be generated via OpenSSL with the following command line.
openssl req -new -newkey rsa:1024 -keyout <filename> -nodes -x509 -out <filename>
For further possibilities, please stick with the OpenSSL documentation under
Here HTTP and HTTPS server can activate/deactivate or their ports can be edited. It
should be noted that these ports are not used already by other services. HTTP and HTTPS
ports pass automatically the firewall
For some services, it is necessary that the date is set correctly. For this, several NTP time
servers can be given next to the time zone.
The syslog function allows you to record log messages from daemons, cronjobs, the au-
thentication etc. You get a summary of reports on the site State. Alternatively a Remote
syslog server can be employed. The local syslog uses the local main memory and it is only
The router has an USB Device connection. You need a USB cable for the connection. The
operation mode of this connection is configurable. You can choose between following
operation modes in „USB Device Function“:
Serial connection (console)
If you choose „no“, functionality is switched off.
The USB interface will be available as virtual console interface by selecting „Serial connec-
tion“. That is also the delivery status.
With a connected LINUX PC a serial device like /dev/ttyACMx will exist, allowing link with
a terminal program (e.g. minicom). You need a driver for Windows. It can be installed with
the file linux-cdc-acm.inf. Getting this driver on FMN website under „Downloads“ or on the
USB mass storage device of the router (see below).
Configuration over the web interface
To Next Page
Loading...