What to do if my FMS Toy aircraft will not respond to the throttle?
If your FMS Toy aircraft isn't responding to the throttle but responds to other controls, it could be due to a couple of reasons. First, the ESC might not be armed; try lowering the throttle stick and throttle trim to their lowest settings. Alternatively, the throttle channel might be reversed. If that's the case, reverse the throttle channel on your transmitter.
Why is my FMS Toy aircraft losing power?
If your FMS Toy aircraft is losing power, this could be due to damage to the motor or battery. Inspect the batteries, transmitter, receiver, ESC, motor, and wiring for any signs of damage, and replace components as needed.
What to do if the motor power pulses then loses power on my FMS Toy?
If the motor power pulses and then loses power on your FMS Toy, it could be due to a loss of power to the aircraft. Land the aircraft immediately and recharge the flight battery. Another potential cause is that the ESC uses a default soft Low Voltage Cutoff (LVC). Check the connection from the ESC to the receiver.
Why is my FMS Toy aircraft's flight time reduced or underpowered?
If you're experiencing reduced flight time or your FMS Toy aircraft feels underpowered, the flight battery charge might be low. Completely recharge the flight battery. Alternatively, the flight battery could be damaged. If so, replace it and follow the flight battery instructions.
Why are the controls reversed on my FMS Toy?
If the controls are reversed on your FMS Toy, the channels are likely reversed in the transmitter. Perform the control direction test and adjust the controls for both the aircraft and the transmitter accordingly.
What to do if a control surface on my FMS Toy does not move or is slow to respond?
If a control surface on your FMS Toy doesn't move or responds slowly to control inputs, there might be damage to the control surface, control horn, linkage, or servo. Replace or repair any damaged parts and adjust the controls. Another possibility is damaged wires or loose connections. Check the connections for any loose wiring.
Why is my FMS Toy making extra propeller noise or vibrating?
If you notice extra propeller noise or vibration with your FMS Toy, it could be due to a damaged spinner, propeller, motor, or motor mount. Replace any damaged parts. Another cause could be loose propeller and spinner parts, so tighten the parts for the propeller adapter, propeller, and spinner.
What does it mean when the LED on the receiver of my FMS Toy flashes slowly?
If the LED on the receiver of your FMS Toy flashes slowly, check the servos for damage and the linkages for binding.
General| Wingspan | 750mm |
|---|---|
| Material | EPO foam |
| Motor | Brushless outrunner |
| Type | Aerobatic Airplane |
| Control | 4 Channel |
| Servos | 9g digital servos |
| Radio | 2.4GHz |
| Recommended Skill Level | Intermediate |
Details safe use and disposal of Li-Po batteries, emphasizing risks of mishandling.
Provides instructions for safely charging the flight battery, recommending specific chargers and bags.
Details ESC safe start, motor rotation, brake settings, and battery selection for flight readiness.
Explains how to balance the model by adjusting the battery for the correct center of gravity.
To Next Page
