Fobis Technologies Weemote X User Manual

6 | WEEMOTE.COM 7 | WEEMOTE.COM
WHAT THE BUTTONS DO (CONTINUED): 1. INSTALL THE BATTERIES
2. REMOVE THE SETUP COVER
Channel Up/Down Control: The channel up/down control is
factory set to work just like any standard remote control. This control
can also be optioned to only cycle through favorite channels 6-10, if
programmed. If you set the channel up/down option for favorite chan-
nels, this control will no longer access all available channels on your
TV. You also want to use this mode for kids to control channel access.
This control can also be turned completely off and you can learn the
channel controls from your existing remote control.
Programming Buttons: Used to setup your weemote
®
. These
buttons are only accessible when you remove the setup cover of the
weemote
®
. Since these buttons are secured after you program the
weemote
®
, your settings are always protected. All programming infor-
mation is stored in permanent memory, regardless of battery levels.
The “A” button is used to enter any TV or Set-top codes needed
to operate your weemote
®
. Information on how to enter codes are
covered in this guide.
The “B” button is used to use the learning features of the
weemote
®
. Information on how use the learning features are covered
in the Reference Guide.
The “C” button is used to program your favorite channels. In-
formation on how to program favorite channels are covered in this
guide. This button is also used to program different option settings.
Information on program options are covered in the Reference Guide.
The “100”, “10” and “1” buttons are used to program in ac-
tual values during setup. For example, to enter a value of 295, you
would press and release the “100” button twice (100 X 2 = 200),
press and release the “10” button nine times (10 X 9 = 90) and then
finally press and release the “1” button 5 times (1 X 5 = 5).
t:PVXJMMOFFEBTNBMMIFBEFE1IJMMJQT
screwdriver and 2 “AAA” batteries.
Don’t use a large head screwdriver—
you will strip the screws!
t*TZPVSIPNFFOUFSUBJONFOUTZTUFNTVQ-
ported? The weemote
®
does not work
with RF based, remote control receivers
found in some satellite receivers.
t/PUFUIBUPOUIFJOTJEFPGUIFCBUUFSZ
door is a product sticker with your prod-
uct code version. When contacting us,
always refer to this product code.
t"GUFSZPVMPPTFOUIFTDSFXUVSOUIFVOJU
around and apply downward pressure
on the setup cover, just below the Favor-
ite #3 and Favorite #4 buttons. Do not
use a screwdriver to wedge the
over open!
t5BLFDBSFOPUUPPWFSUJHIUFOUIFTDSFXT
when you put the covers back on.
Install 2 “AAA”
batteries. Do not
overtighten the
screw!
screw stays
on unit.
screw stays
on cover
HOW IT WORKS STEP 1: GETTING STARTED

Fobis Technologies Weemote X Specifications

General

Brand	Fobis Technologies
Model	Weemote X
Category	Remote Control
Language	English