Focus Bikes bicycle - Page 35

68 Focus Bicycles - Bicycle Owner’s Manual
Appendix E - Tightening Torques/Tire Pressure/Lighting Systems 69
Tightening torques of Shimano components: Continued
Article Specification Tightening Torque
Crank assembly (FC) Crank arm xing screw 35 Nm
Chain sprocket xing screw 10 Nm
Pedals (FC) Pedal axle 35 Nm
Cassettes (HG) Fixing ring 30 Nm
Quick release see page 7
*We recommend the use of plastic mounting paste under the components
Tires and tire pressure
Observe any differing manufacturer’s specications. The tires and inner
tubes could otherwise be damaged.prerequisite in case of warranty
claims.
Conversion table Bar - PSI:
Tire width Recommended Tire Pressure
20mm 9.0 Bar 130 psi
23mm 8.0 Bar 115 psi
25mm 7.0 Bar 100 psi
28mm 6.0 Bar 85 psi
30mm 5.5 Bar 80 psi
32mm 5.0 Bar 70 psi
35mm 4.5 Bar 65 psi
37mm 4.5 Bar 65 psi
40mm 4.0 Bar 55 psi
42mm 4.0 Bar 55 psi
44mm 3.5 Bar 50 psi
47mm 3.5 Bar 50 psi
50mm 3.0 Bar 45 psi
54mm 2.5 Bar 35 psi
57mm 2.2 Bar 32 psi
60mm 2.0 Bar 30 psi
Lighting Systems
Type Power supply
Headlamp,neonbulb 6Volt 2.4Watt
Headlamp,halogen 6Volt 2.4WattHS3
Rearlightw/parkinglight 6Volt 0.6Watt
Rearlight 6Volt 0.6Watt
Rear light, D-toplight plus diode carrier rear light
w/LEDs (no bulb)
Dynamo,right/left-hand 6Volt 3Watt
Hubdynamo 6Volt 3Watt