10
Test Strip
Your system measures the amount of sugar (glucose) in whole blood.
Blood is applied to the absorbent hole on the test strip and is
automatically drawn into the reaction cell where the reaction takes place.
Test Strip Handle
Hold this part to
insert the test strip
into the slot.
Confirmation Window
This is where you confirm
if enough blood has been
applied to the absorbent
hole in the strip.
Contact Bars
Insert this end of the test
strip into the meter. Push
it in firmly until it will go
no further.
Absorbent Hole
Apply a drop of blood
here. The blood will be
automatically absorbed.
To Next Page
Loading...
