Force FS 1000 - Page 12

10
To
Motor Unit
(Back)
Please note the arrow&
DOOR marking, indicates
this side to the door
Slide the trolley
from the back of the
T-rail assembly
Raise the pulley end of the rail so the rail
can sit on the motor unit properly. Attached
the rail to the motor unit by tightening 2
M8*12 self-locking bolts.
CAUTION
Use only the specified bolts to attach
the T-rail to the opener. Any other
bolts will cause serious damage to the
opener.
STEP3: Install the Trolley
STEP4: Attached the T-Rail to the Opener