STEP 5
A) Attach the Upper Cable(75#) through the bracket of Upper frame(4#), Make
sure that the ball stopper should be underneath the frame.
B) Attach one pc Pulley (60#) to the bracket and secure them with one pc
M10*45 Allen Bolt(104#), two pcsφ10 washer(100#) and one pc M10 Aircraft
Nut(97#).
C) Draw the Upper cable(75#) backwards and to the top bracket of the vertical
frame(3#) and then repeat the procedure B to install a pulley.
D) Draw the cable towards the pulley and through the centre of the front press
frame(5#) and then repeat the procedure B to install one pc pulley.
E) Draw the Upper cable(75#) backwards through the hole on the front vertical
frame(3#)and repeat the procedure B to install one pc pulley.
F) Draw the Upper cable(75#)downwards and place one pc pulley onto the cable ,
Secure the pulley to the double floating pulley bracket(17#) with one pc
M10*45 Allen Bolt(104#), two pcsφ10 washer(100#) and one pc M10 Aircraft
Nut(97#).
G) Draw the cable around the pulley upwards , place two pcs pulley to the
opening of rear of the upper frame (4#) and secure them with two pcs
M10*45Allen Bolt(104#) ,four pcs φ 10 washer(100#) ,two pcs L-shape
separation blade(117#),two pcs M10 Aircraft Nut(97#).
H) Draw the cable downwards between the two Guide Rod(13#)to the Selector
Rod (12#),thread the bolt into the opening on the top of the Selector Rod to
secure the cable.
NOTE: Tighten or loosen the end bolt of the upper cable(75#)can adjust the
tension of the cable system. Please make sure the bolt screw inside of the
weight selector rod (12#) at least 5 laps.
10
To Next Page
Loading...
