SETP 2
A)Slide 14 pcs Weight Plate（45#）onto the Guide Rods （13#）from the top to the
bottom，Make sure all the deep grooves on the weight plates face the Front and
downwards. Align the holes and Insert the Selector Rod（12#）into the hole on the
weight plates，and then place the Selector Stem（44#）onto the Selector Rod(12#).
Select the desired number of Weight Plate with L-Shaped Pin（93#）
when doing the exercise；
B)Place the Upper Frame (4#)Onto the 2 PCS Guide Rod（13#）and align the holes,
Secure them with 2PCS M10×25 Allen Bolt（90#）、2PCS φ１０Washer(100#) .
C）Attach the Upper Frame (4#) onto the Front Vertical Frame(3#) and Secure them
with 2 pcs M10×90 Carriage Bolt（88#), one Bracket (31#),2PCSφ10 Washer
（100#）,2PCS M10 Aircraft Nut（97#）.
7
To Next Page
