ProCal 3
Instructions
NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF
FORD PERFORMANCE PARTS.
Questions? http://bit.ly/1KdPDjy or (800) FORD788
Factory Ford shop manuals are available from Helm Publications, 1-800-782-4356
Page 2 of 14
Getting Started
Please visit www. performanceparts.ford.com for the most current instruction information.
! ! ! PLEASE READ ALL OF THE FOLLOWING INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION. AT
ANY TIME YOU DO NOT UNDERSTAND THE INSTRUCTIONS, PLEASE CALL THE FORD PERFORMANCE
TECHLINE AT 1-800-367-3788 ! ! !
ProCal Flash Tool Instructions
Read the instructions below in their entirety prior to beginning the flash procedure. If you have questions or concerns after
reading these instructions, call the Ford Performance Techline at 1-800-367-3788.
This ProCal tool has been designed to deliver a performance calibration to your vehicle and will preserve a copy of your
vehicle’s stock calibration, should you decide to remove the performance calibration for any reason. The tool and
performance calibration are locked to your vehicle and therefore cannot be used on a different vehicle.
Verify Package Contents
ProCal Unit Mini-USB Cable
***TAKE EXTREME CARE THAT YOUR PROCAL VEHICLE INTERFACE UNIT AND THE STOCK CALIBRATION
FILE DOWNLOADED FROM YOUR VEHICLE IN THE FOLLOWING STEPS IS NOT LOST OR DAMAGED;
REPLACEMENTS WILL NOT BE GIVEN***
NEVER OPERATE THE ENGINE UNTIL PROGRAMMING OF YOUR PERFORMANCE CALIBRATION
HAS COMPLETED SUCCESSFULLY. OPERATION WHILE USING THE WRONG CALIBRATION MAY
RESULT IN PERMANENT ENGINE DAMAGE AND WILL VOID ANY WARRANTY (IF APPLICABLE).
FORD PERFORMANCE CALIBRATIONS ARE DESIGNED FOR 91 OR HIGHER OCTANE FUEL. IF
YOU HAVE LOWER THAN 91 OCTANE FUEL IN THE TANK, WAIT UNTIL YOU ARE ABLE TO PUT 91
OR HIGHER OCTANE FUEL IN THE TANK PRIOR TO PROGRAMMING. FORD PERFORMANCE
RECOMMENDS THE USE OF 93 OCTANE FUEL IF AVAILABLE IN YOUR AREA
If a dealer or installation facility has installed and programmed your vehicle, be sure to obtain the
Procal unit, USB cable and PC3 file from the installation facility. It is be required to restore the
previous calibration or make modifications to the vehicle configuration after the vehicle has been
programmed.
To Next Page
Loading...