Seating
and safety restraints
93
• the driver's safety belt is
unbuckled.
• the parklamps/headlamps are in
OFF position.
To reduce the risk of injury,
do not deactivate/activate
the Belt Minder feature while
driving the vehicle.
1. Turn the ignition switch to the
ON position (DO NOT START THE
ENGINE).
2. Wait until the
warning light turns off
(approximately 1Ć2 minutes).
• Steps 3-5 must be completed
within 60 seconds or the procedure
will have to be repeated.
3. Buckle then unbuckle the safety
belt three times, ending with the
safety belt unbuckled. This can be
done before or during Belt Minder
warning activation.
4. Turn on the headlamps, turn off
the headlamps.
5. Buckle then unbuckle the safety
belt three times, ending with the
safety belt unbuckled.
• After step 5, the
will be turned on for
three seconds.
To Next Page
Loading...
