Note: For all vehicles with remote start installed, it is possible to
program all ’real’ keys as MyKeys™, in which case, you will need to use
your remote start system to reset all MyKeys™ as Admin keys by doing
the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your remote start fob.
3. Follow steps 1-4 in the Disable MyKey™ section.
Troubleshooting
Condition Potential Causes
Can’t create a MyKey™ • Key in the ignition is already a
MyKey™
• Key in the ignition is the last
remaining Admin key (there always
has to be at least one Admin key)
• SecuriLock威 Passive Anti-Theft
System is disabled or in unlimited
mode
• Vehicle has been started using a
remote start system that is
programmed as MyKey™. Refer to
MyKey™ with Remote Start Systems
section.
Cannot program the MyKey™
optional settings
• Key in the ignition is a MyKey™
• No MyKeys™ are programmed to
the vehicle. Refer to Create a
MyKey™ section
• Vehicle has been started using a
remote start system that is
programmed as MyKey™. Refer to
MyKey™ with Remote Start Systems
section.
Locks and Security
147
2010 Flex (471)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
