APA Finished
When Active Park Assist has completed the automated steering, the
message center displays ACTIVE PARK FINISHED followed by a chime.
The driver is responsible to assess and correct as necessary the final
parking position and put the vehicle in P (Park).
The system can also be deactivated at any time by the following:
• Pressing the APA control switch.
• Grabbing the steering wheel.
• Exceeding a vehicle speed of 18 mph (30 km/h) for 30 seconds during
Active Park Searching.
• Exceeding a vehicle speed of 6 mph (10 km/h) during automatic
steering.
• Deactivating the AdvanceTrac威 system or the system has activated on
a slippery or loose surface.
• ABS activation or failure.
• Any door (except the driver’s door) opens.
• Something touching the steering wheel.
If a fault is present in the system, the message ACTIVE PARK FAULT
will be displayed followed by a chime. Contact an authorized dealer to
have your vehicle serviced.
The system should not be used if:
• A foreign object (i.e. bike rack, trailer, etc.) is attached to the front or
rear of the vehicle or at another location close to the sensors.
• The front bumper or side sensors are damaged (i.e. in a collision) or
obstructed by a foreign object (i.e. front bumper cover).
• A mini-spare tire is used
Driving
283
2010 Flex (471)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
Need help?
General
