---------------SECTION
B
GENERAL MAINTENANCE (continued)
1.
Retaining spring
'2. Rubber cap
3. Comector
-
~riUe-mounted
Headlights
Remove
the radiator grille and pull the connector,
Figure
74 and
the
rubber cap, from the
rear
of
the
lamp
assembly. Detach the retaining spring and re-
move
the bulb. Re--assemble
in
reverse order.
Adjust
the angle
of
the
headlight beam to avoid
blinding oncoming drivers.
The
headlights
are
secured
to the grille by three
spring-loaded
screws,
Figure 75. The beam may
be
adjusted venically
or
laterally by turning one
or
more
of the
screws
in
or
out,
as
required.
76. Work.lamps, Front/Side/Indicator
Lamps
and Rear/Stop/Indicator
Lamps
To
pin
access to a worlclamp bulb (Figure 76),
peel back
lhe rubber casing and remove the lens/
reOector assembly. Release the spring clip and ex-
tract lhc bulb from
the
back
of
the renector assem-
bly.
All
fmnl/sidc/indicator bulbs and rear/stop/ind-
icator bulbs
are
accessible after removal
of
the
A72
75. Grille-mounted Headlight
I.
Adjuster screws
plastic lens assembly, secured by screws, Figure
76. The bulbs have a bayonet cap and may be
re-
moved by pressing in and turning approximalCly
20" counter-clockwise.
IMPORTANT: When replacing the lens, take
care not to overtighten the retaining screws.
76. Rear Lamp
I. Lens retaining screws
2.
Worklamp casing
31
To Next Page
Loading...
