Handling a second
incoming call
Note:
The second incoming call
function must be activated in your
phone.
If there is an incoming call whilst there
is an ongoing call, a beep will be
heard and you will have the option to
end the active call and to accept the
incoming call.
Accepting a second incoming
call
Second incoming calls can be
accepted by either:
•
pressing the PHONE button
•
pressing the MODE button on the
remote control
•
selecting Accept.
Note:
This will cancel the ongoing
call.
Rejecting a second incoming
call
Second incoming calls can be
rejected by either:
•
pressing the CD/AUX button
•
pressing the RADIO button
•
Selecting Reject.
Changing the active phone
Note:
Phones must be bonded to
the system before they can be made
active.
1. Press the PHONE button.
2.
Select Settings.
3.
Select active phone.
4. Rotate the SELECT button and
select the new phone to become
bonded from the list.
5. Press the SELECT button to
activate selection.
Note:
After bonding a Bluetooth
phone to the system, this becomes
the active phone.
Deleting a bonded phone
A bonded phone can be deleted
from the system at any time, unless
a phone call is in progress.
1. Press the PHONE button.
2.
Select Settings.
3.
Select phone to debond.
4. Rotate the SELECT button and
select the phone to debond from
the list.
5. Press the SELECT button to
activate selection.
Reject all incoming calls
You may set the phone via the
navigation unit to automatically reject
all incoming calls.
1. Press the PHONE button.
2.
Select Settings.
3.
Select Reject all incoming
calls.
4. Press the SELECT button to
activate selection.
32
Navigation telephone control
To Next Page
Loading...
Need help?
General
