Time
This feature changes the way in
which the journey time is shown.
•
Select REMAIN to display the
remaining estimated driving time
to reach the destination.
•
Select ARRIVAL to display the
estimated time of arrival.
Driving recommendation
This feature enables a graphic inset
on all application screens (CD, radio
etc) which shows the next turn or
direction to travel in.
•
Select OFF to disable.
•
Select ALWAYS to turn this on
constantly. A graphic inset will
always be shown even if there is
no direction change or turn
approaching.
•
Select TEMPORARY to activate.
This option will only display the
inset graphic when there is a
direction change or turn
approaching.
Navigation demo
This feature allows you to set any
vehicle start position, and to begin a
demonstration route guidance
scenario if required. Your GPS
position is ignored when activating
this feature and your vehicle does not
need to be moving to begin a route.
•
Select OFF to deactivate. The
system will operate normally using
the GPS sensor and display the
true vehicle position.
•
Select ONCE to enable and run
through a simulated route
guidance plan one time only.
•
Select LOOP to enable a
continuous demonstration mode.
The simulated route will keep
repeating by returning to the start
point once the destination has
been reached.
To enter a simulated vehicle position,
select the manual position button.
This will allow entry of an address in
the usual manner.
Start manual calibration
It may be necessary to periodically
calibrate the navigation system, in
order to maintain position accuracy.
Press the select button to
re-calibrate the navigation system.
Follow the on screen instructions.
Radio
News
This feature will interrupt normal
reception to broadcast news bulletins
from stations on the FM waveband,
in the same way as traffic information
is provided. News interrupts are
broadcast at the same preset volume
level as traffic announcements. You
can turn this on and off.
14
System settings
To Next Page
Loading...
Need help?
General
