1. Pull the wiper blade and arm away from
the glass.
Note: Do not hold the wiper blade to lift the
wiper arm.
2. Press the wiper blade locking clip.
3. Remove the wiper blade.
Note: Make sure that the wiper arm does not
spring back against the glass when the wiper
blade is not attached.
4. To install, reverse the removal procedure.
Note: Make sure that the wiper blade locks
into place.
REPLACING THE REAR WIPER
BLADES
1. Lift the wiper arm.
Note: Do not hold the wiper blade to lift the
wiper arm.
Note: Do not lift the wiper arm beyond the
limited service-up position, as this might cause
damage to the wiper arm. The limited
service-up position is intended to protect the
wiper arm against car washes.
2. Remove the wiper blade.
Note: Make sure that the wiper arm does not
spring back against the glass when the wiper
blade is not attached.
3. To install, reverse the removal procedure.
Note: Make sure that the wiper blade locks
into place.
101
Expedition (TBD) Canada/Mexico/United States of America, enUSA, Edition date: 202406, DOM
Wipers and Washers