3. Press and hold the desired pre-set
button B until a single chime sounds
to confirm.
Recalling a stored seat position
Note: To stop seat movement during a
recall, press any driver seat adjustment
control, any of the memory buttons or any
mirror control switch. Seat movement will
also stop if you move the vehicle.
Passive recall
Note: If more than one passive key is in
range, the memory function will move to the
settings of the first key stored.
When you unlock the vehicle with the
remote control or pull the driver door
handle with a passive key in range, the seat
and mirrors will move to the position stored
on that remote control or passive key.
Active recall
Press the pre-set button associated with
the desired driving position. The seat and
mirrors will move to the position stored on
that pre-set.
Resetting the memory
If any seat position travel is interrupted
(e.g. an obstacle in the way or loss of
power supply), you will need to reset the
memory.
Note: Make sure all electrical accessories
are switched off.
1. Turn the ignition to position II.
2. Operate the seat adjustment control
to move the seat in the required
direction until it stops. See Power
Seats (page 120). A click will be heard.
3. Release the seat adjustment control
and immediately press and hold the
switch in the same direction for at least
3 seconds. Keep it held until the seat
stops at the mechanical end of its
travel and a click is heard.
4. Release the seat adjustment control.
5. Operate the same seat adjustment
control in the opposite direction for at
least 3 seconds. Keep it held until the
seat stops at the mechanical end of its
travel and a click is heard.
GLASSES HOLDER
To Next Page
Loading...
Need help?
General
