• For auxiliary customer electrical loads, a
suitable fused connection must be used.
• If multiple auxiliary loads are required, it is
recommended that an auxiliary fuse box is
fitted to the vehicle.
• For the connection of auxiliary exterior lighting,
refer to the guidelines given in the exterior
lighting section.
Refer to: 4.3 Exterior Lighting (page 63).
Auxiliary loads for external devices which require
an ignition feed (such as UHF/CB radios) may be
connected via a relay energised by a IG+ feed to
the Body Control Module.
WARNING: Under no circumstances
should the IG+ feed be used to drive
auxiliary loads directly. A suitable relay
must be used.
The Body Control Module is positioned on the
driver's side of the vehicle underneath the dash
panel.
IG+ Connection at Body Control Module
DescriptionItem
Body Control Module1
IG+ Feed2
Part Numbers
ManufacturerPart Number / Service
Part Number
Description
TE (Tyco Electronics)CU5T-14489-XAConnector
Molex7C3T-14474-DA / DU2Z-
14474-DA
Pin
Date of Publication: 02/2017
FORD RANGER 2015
To Next Page
Loading...
