Instructions for connection
1. The vehicle speed output is available on:
[connector 3 pin number 52] or [connector 4
pin 3]. Choose one of the connections and
populate the connector with a terminal and
wire.
2. The output must be connected to a device with
1k ohms resistance (600 ohms to 2k ohms is
the guideline) in order for it to work. This
protects the BCM (body control module) from
overcurrent risk.
3. The output must be connected to a power
source.
4. Once the device is connected, reset the BCM
by disconnecting the vehicle battery.
5. Reconnect the vehicle battery.
6. Turn the ignition ON.
7. The signal should now be available.
NOTE: Rload should be present and connected
to battery voltage for this function to work.
For Information Only
Terminal part number: 96AG-14474-RSA.
Wire size and color: 0.5 CSA, blue - green.
Date of Publication: 02/2017
FORD RANGER 2015
To Next Page
Loading...
