PRODUCT FEATURES
• 32bit microprocessor, color display and graphing
• Rugged industrial design and build
• ABS and rubber housing, explosion proof
• Rechargeable Lithium-ion battery via easy USB charger
• Professional aluminum hard-case
• ATEX, CNEX, FCC, IP65 certifications
• Built-in pump and easy 3mm barb hose connector
1. INTRODUCTION
You have purchased the FD-600 INDUSTRIAL GAS DETECTOR by FORENSICS
DETECTORS
TM
. The detector is factory calibrated, TURN ON AND GO! This
product is a INDUSTRIAL gas analyzer with graphing, color display and alarm
logging. This detector is made with a robust ATEX design using high quality
electrochemical sensors made in the UK. This detector was made for industrial
usage for oil and gas professionals, technicians, contractors, food technology
engineers, energy inspectors, and many other applications that need to analyze
air quality in with precision pump control. This detector is made to endure harsh
handling with Explosion-proof grade of Ex ib IIB T4 Gb and Protection Grade:
IP65.
2. QUICK SETUP
1. Ensure all components are included.
2. Ensure analyzer is fully charged.
3. Double check all tubing is well connected and in place.
4. Turn ON the detector. After countdown the pump turns ON and READY.
5. Start measuring. Real-time measurements are shown on the HOME screen.
6. Read this manual and familiarize yourself with the operation.
7. Always be safe.
8. Before turning OFF, flush/purge the air out the detector by allowing the pump
to run for 60 secs to allow fresh air to purge the instrument.
9. Ensure tubing and items are clean before storing as to avoid any
contamination, residual odors or toxic gases that may poison the sensor.
To Next Page
Loading...
