ALARM SETTINGS
AlarmSet: Alarms are triggered (LED flashes, Buzzer and Vibration) when
alarms points are met/exceeded. To change the alarm set points select
AlarmSet in the Main Menu (see prior section). A screen to select your gas will
appear like the image below on the left. Select your gas and edit to change the
alarm set point / trigger point as shown in the right image. When alarms are
triggered a warning symbol is shown within the corresponding gas display
section within the HOME DETECTION SCREEN. When triggered, the alarm is
highlighted in YELLOW (LOW alarm) or RED (HIGH alarm) on the HOME
Detection Screen. To avoid any annoying alarm, set the alarm either as LOW or
HIGH as possible so the alarms are not triggered.
**NOTE: If ALARM triggers are critical to your application, always check the
alarm setting to ensure you are protected and alarm settings are as you
anticipate to avoid harmful exposure levels.
To Next Page
Loading...