8
H
OW TO USE
WARNING: Follow each step in the treatment process ensuring you complete all aspects of
each step before progressing to the next.
PREPARE THE TREATMENT AREA
Remove any visible hair on the skin before using the device. We recommend shaving body hair
and dermaplaning facial hair, for optimal results. Make sure there is no hair remaining above the
surface of the skin as this may cause injury. This also prevents debris from covering the front of
your device. Clean the treatment area and pat it dry.
TURN ON THE DEVICE
Attach the relevant plug adapter to the power cable. Then use the power cable to connect
the device to an electrical outlet. The device will turn on automatically. You can adjust to your
preferred intensity level using the + and - buttons.
NOTE: Levels 1 - 3 on your device are intended for sensitive areas and first time users. With
reduced light intensity, more treatments may be required to see the desired effects. As long as
the treatment feels comfortable, increase the setting by one level.
PATCH TEST
Before your first treatment on each new body area, we RECOMMEND you test your skin in
that area for a reaction to the device. The patch test area should be approximately 3cm x
3cm in size (equivalent to 1 flash from PEACH
™
). Perform the patch test as described below
in the ‘Treatment Methods’ section, under ‘Stamp Mode’. Wait 24 hours following the patch
To Next Page
Loading...
