14
THE BARRE
The barre can be easily attached in two simple steps. First, insert the two metal arms that
hold the barre into the keyholes behind either side of the Studio. Insert the arm at the top of
the keyhole, then slide it down into place. Lock each arm in position by pushing the protruding
lever down toward the arm. Now your studio is ready to hold the barre.
With the caps at the end of the barre unscrewed, line the T-shaped hook on each arm with the
hole on the underside of the barre. Insert the T-hook into the barre and screw the ends of the
caps tightly into place.
To detach the barre, simply unscrew the caps at each end to loosen, lift the barre up and o
the T-hooks, and stowe. Remove the metal arms at the back of the studio by lifting the lever to
unlock the arm, and then pulling each arm up and out of the keyhole.
STUDIO | Barre Accessory
To Next Page
Loading...
Need help?
General