8
POWERING ON + OFF
To wake the Studio, touch the display. The Studio goes to sleep
automatically a few minutes after you stop using it. You can also
manually put the Studio to sleep or restart it using the touchscreen
menu. In sleep mode, the Studio uses very little electricity.
If the Studio does not wake up when you touch the display, it can be
turned on by pressing the power button. The round power button
is located below the right camera on the rear of the Studio. When
the Studio is on, pressing the power button will put it to sleep, or
holding down the button for 4 seconds will shut it down.
There is an installer power switch located near the power cord. Your
installer will switch this to ON and it should remain in this position.
Power
Button
STUDIO | Getting Started
To Next Page
Loading...
Need help?
General