19
THE BARRE
To attach the Barre accessory, locate the plastic magnetic covers on each side of the Lift. Push
the top or bottom of the cover to open and remove to uncover the keyhole for the metal arms.
Slide the metal arms on each side through
the keyhole adaptor and lock the latch.
Place the wooden bar with the openings aligned
with pins on the metal handles.
Tighten the caps on each end of the wooden
bars until it’s secure.
To detach the barre, simply unscrew the caps at each end to loosen, lift the barre up and o the
T-hooks, and stow. Remove the metal arms at the back of the studio by lifting the lever to unlock
the arm, and then pulling each arm up and out of the keyhole.
STUDIO LIFT | Barre Accessory
To Next Page
Loading...