Forte F24DWS650PR - Step 6: Install the 90° Water Supply Elbow

UP
DOWN
1
Step 6: Install the 90° water supply elbow
1 Wrap the male thread of the 90° elbow with Teflon thread seal tape twice. Do not use plumber's putty.
2 Install the 90° elbow onto the water valve. Do not overtighten the 90° elbow. The water valve bracket could bend or the
water valve fitting could break.
3 Position the end of the elbow to face the floor when the dishwasher is upright.
You’ll need:
Adjustable wrench
90° elbow
Teflon thread
seal tape
4