4
the doors are opened, Ready Mode will deactivate and the vehicle will not start until Ready Mode is
reactivated.
METHOD 1 ACTIVATION :
STEP 1
and
Make sure that all doors are closed and the transmission
is in the NEUTRAL position.
STEP 2
Engage the parking brake.
STEP 3
Release the brake pedal.
STEP 4
Within 20 seconds push the START button.
The parking lights will flash once and then remain on.
STEP 5
Remove the key from the ignition barrel.
The vehicle will remain running with the Remote-Starter.
STEP 6
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are
closed.
STEP 7
Lock the doors by pushing the LOCK button.
METHOD 2 This method must be enabled by the installer during installation.
ACTIVATION:
STEP 1
Make sure the transmission is in the NEUTRAL position.
STEP 2
Engage the parking brake.
STEP 3
Release the brake pedal.
STEP 4
Remove the key from the ignition barrel. The engine will
shut down and the vehicle will be ready to start at any
time.
STEP 5
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors
are closed.
The vehicle is ready to start. Open any door to cancel Ready Mode and re-begin the
sequence from step 1.
TO DEACTIVATE READY MODE:
• Open any door(s) • Open the hood • Disengage of the parking brake
Note
: If the parking lights flash 3 times when Remote-Starting, Ready Mode is not enabled.
DRIVING OFF
When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following
steps:
STEP 1
Insert the key and turn it to the ignition (ON/Run) position.
WARNING: Do not turn the key to the START position when the
engine is running. This may damage the ignition system on some
vehicles.
STEP 2
Step on the brake pedal to disable the Remote-Starter,
and put the vehicle in gear.
To Next Page
Loading...
