29
5 Approved Antennas
Only approved antennas may be used in conjunction with AP832 access points. Access
Points have been designed to operate with the antennas listed below. Antennas not included
in this list are strictly prohibited for use with these devices. The required antenna impedance
is 50 ohms.
TABLE 5: Approved Antennas
Part Numbers Gain Description
MERU-PI623 3/4 dBi Internal PIFA dual-band antenna
ANT-ABGN-23O-W 2/3 dBi Dual-band Omni-directional dipole
ANT-ABGN-23 3/4 dBi Dual-band ceiling mount Omni-directional
3-lead
ANT-6ABGN-24 2.5/4 dBi Dual-band ceiling mount Omni-directional
6-lead
ANT-ABGN47O 4.7/4.7 dBi Dual-band high gain dipole Omni-direc-
tional
ANT-O6ABGN-0606-O 6/6 dBi Dual band Omni-directional 6-lead
ANT-I2ABGN-0304-O 3/4 dBi Dual-band ceiling mount Omni-directional
2-lead
ANT-I3ABGN-0304-O 3/4 dBi Dual-band ceiling mount Omni-directional
3-lead
ANT-O4ABGN-0607-
PT
6/7 dBi Dual-band wall-mount patch 4-lead
ANT-O6ABGN-0607-
PT
6/7 dBi Dual-band wall-mount patch 6-lead
ANT-ABGN-0406-W 4/6 dBi Dual band Omni-directional antenna single-
feed
To Next Page
Loading...
