196 Fortinet Inc.
IP/MAC binding Firewall configuration
Viewing the dynamic IP/MAC list
1 Go to Firewall > IP/MAC Binding > Dynamic IP/MAC.
Enabling IP/MAC binding
1 Go to Firewall > IP/MAC Binding > Setting.
2 Select Enable IP/MAC binding going through the firewall to turn on IP/MAC binding for
packets that could be matched by policies.
3 Select Enable IP/MAC binding going to the firewall to turn on IP/MAC binding for
packets connecting to the firewall.
4 Configure how IP/MAC binding handles packets with IP and MAC addresses that are
not defined in the IP/MAC list.
Select Allow traffic to allow all packets with IP and MAC address pairs that are not
added to the IP/MAC binding list.
Select Block traffic to block packets with IP and MAC address pairs that are not added
to the IP/MAC binding list.
5 Select Apply to save your changes.
Figure 15: IP/MAC settings
Caution: Make sure that you have added the IP/MAC Address pair of your management
computer before enabling IP/MAC binding.
To Next Page
Loading...
