Fortinet FortiGate 400

To Next Page

To Previous Page

48 Fortinet Inc.

Using the command line interface NAT/Route mode installation

3 Set the IP address and netmask of interface 2 to the external IP address and netmask

that you recorded in Table 10 on page 45.

set system interface port2 mode static ip <IP_address>

Example

set system interface port2 mode

static

ip 204.23.1.5

255.255.255.0

4 Set the IP address and netmask of interface 3 or 4 to the IP addresses and netmasks

that you recorded in Table 10 on page 45.

set system interface <interface_name> mode static ip

<IP_address> <netmask>

Example

To set the IP address of interface 3 to 192.45.56.73 and netmask to 255.255.255.0,

enter

set system interface port3 mode

static

ip 192.45.56.73

255.255.255.0

5 Confirm that the addresses are correct. Enter:

get system interface

The CLI lists the IP address, netmask and other settings for each of the FortiGate

interfaces.

6 Set the primary DNS server IP addresses. Enter

set system dns primary <IP address>

Example

set system dns primary 293.44.75.21

7 Optionally, set the secondary DNS server IP addresses. Enter

set system dns secondary <IP address>

Example

set system dns secondary 293.44.75.22

8 Set the default route to the Default Gateway IP address.

set system route number <route_no> dst 0.0.0.0 0.0.0.0 gw1

<gateway_ip>

Example

set system route number 0 dst 0.0.0.0 0.0.0.0 gw1 204.23.1.2

Fortinet FortiGate 400 - Page 48